4.0 - POWER SUPPLY CONNECTIONS
WARNING: In order to guarantee the utmost safety, connect the apparatus only to a properly
earthed mains system.
The projector is designed to work at the tension and frequency indicated by the electrical data la
-
bel on the rear. Before connecting the projector to the mains, a qualified electrician must check its
conformity.
•
The projector must be protect by an adeguated magneto-thermal switch .
•
Don't power the unit with a dimmer circuit.
Power : indicated in the the serigraphy table (tollerance: +5% / -10%)
4.1 - DMX 512 CONNECTIONS
Connect the projector and the control unit to a wire in conformity with the EIA RS-485 standards: braided bipolar,
shielded, 120 ohm of characteristic impedance, 22-24 AWG, equipped with Cannon 3 Pin XRL plugs. Respect the
DMX 512 signal input and output according to the panel indications. A terminal pin with 120 ohm resistance (¼ Watt
minimum) must be inserted between the terminals 2 and 3 in the last piece of apparatus.
Should there be different electrical characteristics or special steps to be carried out, please contact COEF by
Supply the projector by connecting it as indicated in picture.
Comments to this Manuals