COEF PERFORMANCE 250DV DV User Manual download pdf (Page 45)

ScancommanderScancommander

Scancommander

Tel.: +49 931 497940

User's Manual Scancommander

4545

6.2.5 Playback of a sequence with programmed STEP MODE

STEP MODE buttons switched off

(All red LED´s off)

SEQUENZ button 1-16

GREEN LED´s inside the SET MODE buttons

Show the step mode of the next step, as it was set

when programming the sequence. If one of the green

LED´s is on, the sequence waits for a trigger signal.

By the GO button the next step can be recalled any

time.

No green or red LED inside the SET RATE buttons

The next step will follow automatically as soon as the

STEP TIME of the last step runs out.

Note:

The yellow LED inside the SET RATE button will not

show the internally programmed STEP TIME, but will

always show the rate set by the fader.

Green LED´s indicating

internal STEP MODE

Running a sequence with

internally stored STEP

MODE

Sequence recall without

going back to step 1

ENABLE button.

Keep button pressed ...

... and simultaneously press ...

Sequence button of the actual sequence

The next step of the sequence is enabled to control

all channels according its step matrix.

6.2.6 Enable Sequence

The ENABLE function like on Enable Chaser allows a sequence to resume

control of all channels without starting at step 1. A sequence, which has lost

access to some channels because of a direct access or memory recall, can

now continue as programmed.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 128 129

No comments

COEF PERFORMANCE 250DV DV User Manual Page 45